|
I'll try to make my instructions easy to scan, but also as specific as possible. Where appropriate, I'll include pictures
that illustrate the steps. Here's an example of format I might use for an instruction page:
The following is a QRP 40 Meter Station on the go. As you can see is all setup in one place and ready to go.
Either for Camping, to the Beach or any special event. Its all attached and place in the board as shown; also an amplified
speaker on the same board not shown here. Basiclly is a plug and play including the lighter and batteries connectors.
This is a top view from the QRP Station!
Also everything with the exception of the power supply is MFJ and the speaker not shown here. The power
supply is only 2.5 Amps. enough for the Amplified speaker, MFJ CUB, MFJ Econo Keyer and the Miniature Travel Iambic Paddle.
Portable 40 meter QRP Antenna/Base.
As you can see i found an old Camera Stand perfect for travel; just snap on the antenna or wich
ever one you have and get on the air. In this case is also the MFJ 40 Meter QRP Whip antenna. Just a few modifications
for setting the antenna in place like shown and your on the air in less than a few minutes!
Here you can see the antenna connector wich is a snap on type and the still coiled ground cable attached
and hanging to the base where the Antenna connects to the Coax ready to be streached for use. The good thing about using this
camera stand is the swivel part where you can actually adjust your antenna into any position from vertically, horizontally
or on an angle.
|
